Honda GC190 User Manual

STOP SWITCH WIRE [With oil level switch]
INSTALLATION:
Pass the stop switch wire through the back side of the ignition
coil as shown.
14 mm SPECIAL NUT/FLWHEEL
REMOVAL:
1) Remove the ignition coil
2) Holding the flywheel with a commercially available strap
wrench, remove the
14 mm special nut. I
CAUTION:
Do not loosen the nut by using a screw driver or equiva-
lent tool on the fan blade or projection.
3) Set the magnetic parts of the flywheel in the position shown.
PROJECTIONS I I
I
I
I
14 mm SPECIAL NUT
MAGNETIC
PARTS
gc160_gcaha_3599750_3721672

Honda GC190 Specifications

General

Brand	Honda
Model	GC190
Category	Engine
Language	English