PlSTON/CONNECTlNG ROD
REASSEMBLY:
1)
Apply oil to the piston pin, piston pin hole and the connect-
ing rod small end.
2)
Set the piston
so
that the
"V"
of the
"FW
V'mark stamped
at the back
of
the piston points down.
3)
Set the connecting rod in the piston
so
that the model mark
by the piston pin hole and the longer side
of
the connecting
rod large end face to the right-hand side.
4)
Apply oil to the piston pin and install
it
in the piston.
5)
Install new piston pin clips.
6)
Install the piston/connecting rod assembly in the cylinder
barrel
PISTON PISTON PIN
\
\
CONNECTING
ROD
To Next Page
Loading...
Need help?
General
