Checking the mowing area / Connecting to a power source
53
5 USAGE
5
USAGE
Checking the mowing area
Before operating the lawnmower, ensure the mowing area is free of
pets and foreign objects.
Turn off the lawnmower before removing any foreign objects.
CAUTION:
- If there are any holes (such as rabbit holes, etc.) in the work
area, ll them in so that the work area is level. Periodically
check the work area for holes.
Also conrm that the height of the grass is 65 mm or less.
NOTE:
- Adjust the height of the blades to mow the grass within 5 mm. For
details on how to adjust the height of the blades, see “Adjusting
the height of the blades” (M page 57).
65 mm or less
If the grass is taller than 65 mm, cut the grass using a standard lawnmower.
Connecting to a power source
Follow the steps below when connecting to a power source.
Follow these steps in reverse when disconnecting from a power source.
For details on moving the transformer or changing to a different power outlet, contact your dealer.
NOTE:
- Connect the station only to a supply circuit protected by a residual current device (RCD) with a tripping
current of not more than 30 mA.
1
Remove the connector cover from the station.
2
Connect the power cord connector to the station’s internal
connector.
NOTE:
- When disconnecting the connectors, make sure to lift the clip.
3
Attach the connector cover to the station.
(The power cord and boundary wire should go through the notch in the
connector cover.)
Power cord
Transformer
4
Connect the power cord and the transformer connectors.
NOTE:
- When disconnecting the connectors, make sure to lift the clip.
To Next Page
Loading...
Need help?
General
