Honda HRM 520 - 1 OVERVIEW; How the Honda Robotic Lawnmower Works

4
How the Honda Robotic Lawnmower works / Features
Transformer
The transformer must be installed in a shaded area
protected from rain.
Install the docking station with
appropriate boundary wire length.
In the case of this gure, there
must be more than 2 m from the
front of the docking station and
more than 1 m from the rear of
the docking station. For details,
see “Checking conditions for
installation” (M page 12).
Docking station
Pegs
More
than
1 m
More
than
2 m
1
OVERVIEW
How the Honda Robotic Lawnmower works
Conguring the system
The mowing area is determined by the boundary wire that emits a signal; when the
lawnmower detects the boundary it turns and it cuts the grass randomly. When battery
starts running out, it goes back to the docking station.
Features
Mowing start points
You can designate the start points from which the Honda
Robotic Lawnmower will start mowing. Mowing start
points allow your lawnmower to reach other areas which
are difcult to access. Some mowing start points can be
set by laying a boundary wire, increasing efciency.
NOTE:
- You can congure the following start points for
each model:
HRM310: 3 start points
HRM520: 5 start points
Operation timer
The Honda Robotic
Lawnmower has multiple
settings for designating the
day and time the lawnmower
operates. You can congure
the lawnmower to run on
your days off, or during
certain times that are
convenient for you.
Convenience
After conguring the Honda
Robotic Lawnmower, it starts
and stops mowing without any
prompting. When the timed
programme is complete or the
battery’s charge becomes low,
the lawnmower automatically
returns to its docking station and
recharges its internal battery.
Power cord
Robotic LawnmowerBoundary wire
Lay the boundary wire by securing it on the ground
with pegs, or burying it under the ground.