Adjusting the height of the blades
57
5 USAGE
Adjusting the height of the blades
The height of the blades determines how tall or short the grass will be cut.
Test the lawnmower on a small area and adjust blade height according to your preference.
N WARNING
- Make sure to press the manual STOP button before performing the following procedure.
CAUTION:
- Avoid cutting too much at once. Mow gradually step by step (from level 5 to 1.)
- Avoid cutting more than 5 mm of grass at once. If you want to cut more than 5 mm, it should be
done gradually in steps of 5 mm maximum per week. Example: decreasing from 50 to 30 mm
should require 4 weeks with 5 mm steps.
1
Press the manual STOP button.
The control panel cover pops up.
2
Open the height adjustment dial cover with your
nger.
Insert your nger here
and pull up.
3
Turn the dial anticlockwise to lower the blades, or turn the dial clockwise to raise the blades. Use the
numbers on the dial to approximate the height of the blades.
Blade height
Approximate blade heights for each dial position:
Position
Approximate blade height
1 20 mm
2 30 mm
3 40 mm
4 50 mm
5 60 mm
Decrease Increase
To Next Page
Loading...
Need help?
General
