Honda Interceptor 2014 User Manual

Removing & Installing Body Components u Under Cowl
69
Maintenance
Under Cowl
The right and left under cowls must be
removed to replace the engine oil filter.
❙
Removal
1. Park your motorcycle on a firm, level
surface and lower the side stand.
2. Remove the clip A and clips B on both
sides. 2 P. 70
3. Remove the bolt A and bolt B on both
sides.
4. Remove the bolt C (left side only).
5. Remove the right and left under cowls
while carefully releasing the tabs from the
slots of each upper cowl and the slot of
right under cowl from the stay.
u Be careful not to apply weight to the
under cowls.
❙
Installation
Install the parts in the reverse order of
removal.
Bolt B
Clip A
Clips B
Under cowl
Bolt A
Bolt C (Left side only)
Slot
Stay
(Right side only)

Honda Interceptor 2014 Specifications

General

Displacement	782cc
Bore x Stroke	72mm x 48mm
Compression Ratio	11.8:1
Ignition	Computer-controlled digital transistorized with electronic advance
Transmission	6-speed
Final Drive	O-ring-sealed chain
Front Tire	120/70ZR-17 radial
Rear Tire	180/55ZR-17 radial
Rake (Caster Angle)	25.5 degrees
Engine Type	Liquid-cooled 90-degree V-4
Fuel System	PGM-FI with automatic enrichment circuit
Rear Suspension	Pro-Link HMAS single shock with spring preload adjustability
Front Brake	Dual 310mm discs
Rear Brake	Single 256mm disc
Curb Weight	529 pounds
Valve Train	DOHC; 4 valves per cylinder
Fuel Delivery	PGM-FI
Wheelbase (Alternative)	55.5 inches
Front Suspension (Alternative)	41mm inverted HMAS cartridge fork with spring preload, rebound and compression damping adjustability; 4.7 inches travel
Rear Suspension (Alternative)	Pro-Link single shock
Trail	98mm (3.9 inches)