8 - 1
8
Utilities
To Add a Test Code I.D. Prefix to All Symbologies
This selection allows you to turn on transmission of a Code I.D. before the
decoded symbology. (See the Symbology Chart, page A-1) for the single char-
acter code that identifies each symbology.) This action first clears all current
prefixes, then programs a Code I.D. prefix for all symbologies. This is a tempo-
rary setting that will be removed when the unit is reset. For instructions on how
to reset your image scanner, refer to Reset Image Scanner (page 8-1).
Reset Image Scanner
Scanning this bar code causes the image scanner to re-link with the base.
Show Software Revision
Scan the bar code below to output the current software revision, unit serial num-
ber, and other product information for both the image scanner and base.
Show Data Format
Scan the bar code below to show current data format settings.
Add Code I.D. Prefix to
All Symbologies (Temporary)
To Next Page
Loading...
Need help?
General
