Mounting/Dismounting Modules Excel 800
EN1B-0375GE51 R0910
22
Mounting/Dismounting Cross Connectors
Note
The long cross connector (incl. in the scope of the delivery)
can be mounted to the XS824-25 or XSU824-25, as
required (see Fig. 29). It can be dismounted (see Fig. 28)
and, if desired, replaced with one or two short connectors
(optional accessory, see Table 5 on page 7). It is not
permitted to replace these cross connectors with wire.
► Insert a screwdriver on one end of the cross connector
and swivel it to the right and to the left.
► Insert a screwdriver on the other end of the cross
connecter and swivel it to the right and to left until the
cross connector is released.
► If desired, insert another cross connector.
Fig. 28 Dismounting the cross connectors (long cross
connector shown here)
Fig. 29 Mounting the cross connectors (short cross
connector shown here)
Mounting/Dismounting Swivel Label
Holders
Note
A swivel label holder is included in the scope of delivery of
each module.
Use only the (short / long) swivel label holders appropriate
for the given type (pluggable or mixed, respectively) of I/O
module.
Mounting Swivel Label Holders
► Snap the swivel label holder onto the hinges of the
terminal socket / mixed I/O module.
► Apply self-adhesive labels to the holders.
Fig. 30 Mounting the swivel label holder
Dismounting Swivel Label Holders
► Press the hinges together and remove the swivel label
holder.
To Next Page
Loading...
Need help?
General
