EasyManuals Logo

Honeywell HERMetic UTImeter Gtex Chem User Manual

Honeywell HERMetic UTImeter Gtex Chem
76 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
6  www.tanksystem.com
3. General information
3.1 Shipment note
The following parts should be included in the shipment:
•  1 instrument tted out with one battery in the display;
•  1 set of 4 Allen keys: 1.5, 2, 2.5 and 3 mm;
•  1 Operation and Service Manual.
3.2 Initial inspection
Check the contents of the shipment for completeness and note 
whether any damage has occurred during transport. Carry 
out the “Initial test before installing the instrument” to verify the 
good functioning. If the contents are incomplete, or if there is a 
damage, do not use the device, a claim should be lled with the 
carrier immediately, and Enraf Tanksystem SA Sales or Service 
organization should be notied in order to facilitate the repair or 
replacement of the instrument.
3.3 Documentation discrepancies
The design of the instrument is subject to continuous 
development and improvement. Consequently, the instrument 
may incorporate minor changes in detail from the information 
contained in the manual.
3.4 Warranty
Two (2) years after installation but max. 30 months after
delivery ex works except batteries.
The Vendor undertakes to remedy any defect resulting
from faulty design materials or workmanship. The Vendor’s
obligation is limited to the repair or replacement of such
defective parts by his own plant or one of his authorized
service stations. The Purchaser shall bear the cost and
risk of transportation of defective parts and repaired parts
supplied in replacement of such defective parts.
When returned to Enraf Tanksystem SA or any of its agreed
Service Stations equipment must be contamination-free.
If it is determined that the Purchasers equipment is
contaminated, it will be returned to the Purchaser at the
Purchasers expense. Contaminated equipment will not be
repaired, replaced, or covered under any warranty until
such time that the said equipment is decontaminated by
the Purchaser.
The Purchaser shall notify by fax, telex or in writing of any 
defect immediately upon discovery, specifying the nature 
of the defect and/or the extend of the damage caused 
thereby.
Where no other conditions have been negotiated between the 
Vendor and the Purchaser “General Conditions 188” of United 
Nations shall apply.
This instrument has been certied as Intrinsically Safe 
Instrumentation for only those classes or categories of 
hazardous areas stated on the instrument label, bearing the 
mark of the applicable approval authority. No other usage is 
authorized.
Unauthorized repair or component replacement by the 
Purchaser will void this guarantee and may impair the intrinsic 
safety of the instrument. In particular it is not allowed to repair 
electronic circuits. 
In no event shall Enraf Tanksystem SA be liable for indirect, 
incidental or consequential loss or damage or failure of any kind 
connected with the use if its products or failure of its products to 
function or operate properly.
Enraf Tanksystem SA do not assume the indemnication for any 
accident or damage caused by the operation of its product and 
the warranty is limited to the replacement of parts or complete 
goods.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honeywell HERMetic UTImeter Gtex Chem and is the answer not in the manual?

Honeywell HERMetic UTImeter Gtex Chem Specifications

General IconGeneral
BrandHoneywell
ModelHERMetic UTImeter Gtex Chem
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals