Mounting Addressable Modules Installation
HPFF8(E)/HPFF8CM(E) NAC Expander — P/N 53499:B4 10/1/2018 23
2.5.1 Mounting Modules from Honeywell Fire Systems
Addressable modules can be mounted directly to the Control circuit board as shown in Figure 2.14 for the wall cabinet. This allows wir-
ing to remain in the cabinet. Two modules can be mounted on top of each other if the application requires two independent inputs, such
as silencing. Alternately, two outputs of a six-output addressable module can also be used. The six-output module can also be mounted
directly on the Control board.
Mounting addressable modules on the Control circuit board is also possible in the HPFF8CM and HPFF8CME units. However, the six-
output module has to be mounted in an optional multi-module chassis if used in the large cabinet enclosure.
See Section 2.6, “Power-Limited Wiring Requirements”.
TB3
TB4TB1
TB2
SW2
LEDs
REF+ REF– + IN – IN
+ OUT
– IN
+ OUT+ OUT
+ IN
– OUT
SIGNAL 1
SIGNAL 2
BATT+ BATT–
A+
N/O
N/C COMM
N/O
N/C COMM
AC FAIL
TROUBLE
J1
J2
1L1 1L2 2L1 2L 2 3L1 3L2 4L1 4L2A–
F
F
8
1
2
m
n
t
c
m
f
.
w
m
f
Figure 2.14 Mounting Details for Control & Relay Modules from Honeywell Fire Systems
standoff standoff
standoff standoff
To Next Page
Loading...
Need help?
General
