-.
-.-.
-.
',)&'
Armed Stay
5200-100-017-V0
Phone
More
Message
Zones
Disarm
10:18 AM June 8, 2010
System
4. At the end of the exit delay the system announces
“Armed Stay” and displays the “Armed Stay” screen.
If an invalid User Code is entered or if a valid user code has not been entered within 10 seconds, the system
will return to the “security” screen and it will not be armed.
Auto Stay Arming Feature
' &@ H<(I! @ &9< =&96&@
!<& .0!0&0 &.0& *
./.05:&;'0& * *%@ !<&
.0!0
NOTE: If the exit route entry/exit sensor is in a check condition or has been bypassed it will result in a loss of interior protection because the
alarm system will arm STAY in this case. Consult with your installer for servicing of the entry exit zones or to turn off this feature if a
check condition on entry exit zones occurs.
Arming in Night Stay Mode
7 & * @E&! &!<&@
&:*&;@
&&! & & * 0 &
J)@* * /0& &
! ) *& A )& &* " &
& & & * ! * 8& & &
&&9 &(* !<&@ &&
A&@ ) * H) *
&*& & * @ &
&&
'*& @&&
& ! &&& @ )
When NIGHT-STAY mode is on, the selected interior zones are armed and cause an alarm if anyone enters those
areas (e.g., waking in the middle of the night). To avoid sounding an alarm, you must disarm the system before
any activity takes place in those interior zones.
The Guest Code and Installer Code cannot disarm the system unless it was used to arm the system. In addition,
if the system is armed by pressing via Quick-Arming, neither the Guest Code nor Installer Code can disarm the
system.
Ready To Arm
5200-100-014-V0
Arm Away
Delay
Phone
More
Message
System
Arm Stay
10:18 AM June 8, 2010
Zones
1. Select the Arm Stay icon, the system beeps once and
displays a keypad.
To Next Page
Loading...
Need help?
General
