Honeywell LYNX Touch Security System User Manual

– 28 –
SECURING THE PREMISES
SECURING THE PREMISESSECURING THE PREMISES
SECURING THE PREMISES
Bypassing Protection Zones
Bypassing Individual Zones
The Bypass feature can be used when you want to intentionally arm your system with one or
more zones unprotected. Bypassed zones are unprotected and will not cause an alarm when
violated while your system is armed. All bypasses are removed when an Off sequence
is performed. The system will not allow panic, fire or CO zones to be bypassed.
Bypassing Zones
Ready To Arm
5000-100-006-V1
Arm Away
Delay
Phone
More
Automation
Message
Zones
Arm Stay
72
10:18 AM June 8, 2010
1. With the system in the disarmed state,
select the “Zones” icon. The system displays
the Zones/Bypass screen.
Not Ready To Arm - Fault
5000-100-141-V0
2. Front
Door
Select
Fault
FAULT
Bypass All
Faulted
Bypass
Clear
Bypasses
2. Select the zone(s) that you wish to bypass
and then select “Bypass” OR if programmed,
the “Bypass All Faulted” button allows you to
bypass all faulted zones (excluding Panic,
Fire or CO zones). The system displays a
keypad.
Not Ready to Arm - Fault
Bypass Selected Zones
Enter Code:
Cancel
5000-100-067-V0
231
5
64
0
8
97
Clear
3. Enter a valid Code. The system returns to
the Bypass screen and the zone(s) that are
bypassed will be displayed.
4. Select the 2 icon to return to the home
screen.
5. Arm the system normally. See Arming the
System section for the procedure.

Honeywell LYNX Touch Security System Specifications

General

Brand	Honeywell
Model	LYNX Touch Security System
Category	Security System
Language	English