Honeywell LYNX Touch Security System User Manual

– 47 –
USER FUNCTIONS
USER FUNCTIONSUSER FUNCTIONS
USER FUNCTIONS
Automation
General Information
Automation is used to program triggers, home automation features, send Follow-Me or E-
mail messages of system events or program home automation features (Z-Wave) including
Rules and Scenes (if Z-Wave communications have been enabled). Up to 40 rules can be
programmed. Rules 1 through 20 are used for Triggers, Z-Wave Scenes and Follow-Me
Messages. Rules 21 through 40 are used to trigger Z-Wave Scenes and for E-mail notification
and are only accessible through TotalConnect Service. Check with your Installer to see which
options are available to you.
Note: Switches, Thermostats, Locks, Tools, and Scenes options will only appear when Z-wave has been
enabled.
Rules
The following options are programmed in this section:
Programming Field Action
Rule 1 - 20: Select Rule 1 -20
Note: Rules 21-40 are only accessible through TotalConnect Service.
Name: Name the device
Type: Select the output type
Action: Select the action required for the device
Start Zone Type:
OR
Zone Type Fault:
Select Zone Type to start event*
Stop Zone Type:
OR
Zone Type Restore:
Select Zone Type to stop event*
Start System Operation:
OR
System Operation 1
Select System Operation to start event*
Stop System Operation:
OR
System Operation 2
Select System Operation to stop event*
Zone Number Operation: Select Zone Number to trigger event upon fault, trouble or alarm as selected.
* The displayed field is dependant upon the selection made
Programming Rules
Zones
Arm Away
Ready To Arm
Arm Stay
MoreDelay
Phone
10:18 AM June 8, 2010
5100-100-004-V0
72
Message
Automation
1. With the system in the disarmed state,
select the “Automation” icon from the
Home Screen. The system displays the
Keypad screen.

Honeywell LYNX Touch Security System Specifications

General

Brand	Honeywell
Model	LYNX Touch Security System
Category	Security System
Language	English