Honeywell LYNX Touch Security System User Manual

– 41 –
USER FUNCTIONS
USER FUNCTIONSUSER FUNCTIONS
USER FUNCTIONS
Message Recording and Playback
The LYNX Touch Message Center allows you to record, play and delete messages. The
maximum message duration is 184 seconds.
NOTES: (1) If the system loses electrical power, all messages will be erased.
(2) Message Play/Record will not be available if a report must be sent.
Entering Message Mode
Ready To Arm
5000-100-006-V1
Arm Away
Delay
Phone
More
Automation
Message
Zones
Arm Stay
72
10:18 AM June 8, 2010
1. With the system in the disarmed state,
select the “Message” icon from the Home
Screen. The system displays the Message
screen.
Recording a Message
Ready To Arm
Save
5000-100-045-V0
No items to display!
Add New
Delete All
Play
1. Select “Add New”. The system displays the
Record Message screen.
Note: The System will display the total
message recording time available.
Ready To Arm
5000-100-047-V0
Time Remaining : 184 Seconds
Message 1 Stopped
Record DeletePlay
2. Select “Record”, the system sounds a single
tone. Speak into the microphone and record
your message.
3. When you are finished recording your
message, select. “Stop”
4. To listen to the message, select “Play”.
5. If you wish to delete the message, select
“Delete”.
6. Record additional messages as required.

Honeywell LYNX Touch Security System Specifications

General

Brand	Honeywell
Model	LYNX Touch Security System
Category	Security System
Language	English