Honeywell VISTA-20PSeries User Manual

– 18 –
Arming the System
(cont’d)
Arming Commands
Before arming, close all perimeter doors and windows and make sure the Ready to Arm
message is displayed.
Mode Press these keys… Keypad Confirms By…
STAY
security code +
3
STAY
•
three beeps
•
armed STAY message displayed
•
red ARMED indicator lights
NIGHT-
STAY
security code +
3
STAY
+
3
STAY
•
three beeps
•
NIGHT-STAY message displayed
•
red ARMED indicator lights
INSTANT
security code +
7
INSTANT
•
three beeps
•
armed STAY message displayed
•
red ARMED indicator lights
Note that entry delay is turned off.
AWAY
security code +
2
AWAY
two beeps, or, if programmed, beeping for
duration of exit delay
•
armed AWAY message displayed
•
red ARMED indicator lights
Leave the premises through an entry/exit
door during the exit delay period to avoid
causing an alarm. The keypad beeps
rapidly during the last 5 seconds of the
exit delay to warn you that it is ending.
MAXIMUM
security code +
4
MAX
•
same as AWAY (described above)
Note that entry delay is turned off.
Quick Arming
If "Quick Arming" was programmed by the installer, the
[#]
key can be pressed in
place of the security code when arming the system in any of the arming modes.
However, the 4-digit security code must always be used to disarm the
system.
Function Key Arming
For any arming command, a function key may have also been programmed for your
system. If so, you can press and hold the appropriate function key for 2 seconds to
arm the system. See your installer for the designated functions (see Single Button
Arming section).
Refer to the Accessing Other Partitions section for information on multi-partition
arming (VISTA-20P/PS Series only).

Honeywell VISTA-20PSeries Specifications

General

Brand	Honeywell
Model	VISTA-20PSeries
Category	Security System
Language	English