– 37 –
Scheduling
About Scheduling
The system provides end-user schedules (programmable by master/installer only),
which can control various types of events.
•
Each schedule causes a defined event to start and stop (when appropriate) at a
specified time.
•
Schedules can be set to automatically repeat at various intervals.
•
Schedules can be set for random starting, if desired.
•
VISTA-20P/PS Series provides up to 16 user schedules.
•
VISTA-15P Series provides up to 4 user schedules.
Creating Schedules
1.
+ [#] + [6] [4]
(Master Code)
Alpha Displays:
1 DISARMED
READY TO ARM
2.
Enter a 2-digit schedule number from:
01-16 (VISTA-20P/PS Series) or 01-04 (VISTA-15P
Series).
Press [
∗
] to continue.
ENTER SCHED NO.
00
=
QUIT 00
3.
Enter the desired 2-digit event number from the
following list.
00 = clear the scheduled event
01 = turn a programmed output on or off
ENTER EVENT
(see
Using Device Commands
section for a list of output device numbers
used in your system)
02 = set a user access schedule for one or more users
(see
Security Codes
section for an explanation of access groups)
03 = send a “latch-key” report to a pager if the system is not disarmed by a
specified time; message sent is “777-7777.”
04 = automatically arm the system in STAY mode at a specified time
05 = automatically arm the system in AWAY mode at a specified time
06 = automatically disarm the system at a specified time
07 = Display the word “REMINDER” at a specified time
Press [
∗
] to continue.
4. For event number “01,” enter the output number
associated with this schedule.
Otherwise, this prompt is skipped.
Press [
∗
] to continue to the “Start” prompt below.
DEVICE NUMBER
XX
To Next Page
Loading...
