Using the CLI
Software can also be removed from Compute Nodes using the /opt/clusterpack/bin/clsh tool to
run the swremove command:
z
To remove product PROD1 on all Compute Nodes
%
/opt/clusterpack/bin/clsh /usr/sbin/swremove PROD1
z
To install product PROD1 on just the Compute Node group "cae"
% /opt/clusterpack/bin/clsh -C cae /usr/sbin/remove
PROD1
Using the HPSIM GUI
To remove software to Compute Nodes using HPSIM GUI, do the following:
z
Select "Deploy", "Software Distributor", and then click on "Remove
Software".
z
Select the node(s) and/or node group to install on.
z
This will bring up the swinstall GUI, from which you can specify the software
source and select the software to be installed.
References:
z
3.9.4 How to run HPSIM Web-based GUI
Using the SCM GUI
To remove software to Compute Nodes using SCM GUI, do the following:
z
Under "Tools", select "Software Management", and then double-click on
"Uninstall Software".
z
Select the node(s) and/or node group to install on.
z
This will bring up the swremove GUI, from which you can specify the
software source and select the software to be removed.
References:
z
3.2.3 How to Run SCM Web-based GUI
Back to Top
1.6.5 Update Software in Compute Nodes
To Next Page
Loading...
Need help?
General