account to remove.
All user accounts are administered from the Management Server. Any changes to a users account
will be pushed to all the Compute Nodes using NIS.
References:
z
3.2.3 How to Run SCM Web-based GUI
Back to Top
1.6.8 Change System Parameters in Compute Nodes
Using the HPSIM GUI
To change System Parameters in Compute Nodes using HPSIM GUI, do the following:
z
Select "Configure", "HP-UX Configuration", and then double-click on "Kernel
Configuration - kcweb".
z
Select the node(s) and/or node group to install on.
z
This will bring up the kcweb GUI, from which you can specify the parameters
to change.
References:
z
3.9.4 How to run HPSIM Web-based GUI
z
1.5.1 Create a Golden Image of a Compute Node from the Management Server
z
1.5.2 Distribute Golden Image to a set of Compute Nodes
Using the SCM GUI:
z
Select one or more nodes.
z
Under "Tools", select "System Administration", and then click on "System
Properties".
z
A SAM System Properties window will appear for each node selected.
For greater efficiency and consistency, perform this operation only on a single Compute Node,
and then a golden image be created from that Compute Node and pushed to the other Compute
odes.
References:
z
3.2.3 How to Run SCM Web-based GUI
z
1.5.1 Create a Golden Image of a Compute Node from the Management Server
z
1.5.2 Distribute Golden Image to a set of Compute Nodes
To Next Page
Loading...
Need help?
General