2. Remove the three Phillips M2.0 × 4.0 screws (1) and the three Phillips M2.0 × 2.5 screws (2) that secure
the system board to the computer.
3. Lift the side of the system board upward (3), and then pull the system board away from the connectors
on the side of the computer to remove it (4).
Reverse this procedure to install the system board.
Speakers
To remove the speakers, use this procedure and illustration.
Table 5-13 Speaker description and part number
Description Spare part number
Speaker Kit M50412-001
Before removing the speakers, follow these steps:
50 Chapter 5 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
Need help?
General
