Reverse this procedure to reassemble and replace the display assembly.
Power connector cable
To remove the power connector cable, use this procedure and illustration.
Table 5-14 Power connector cable description and part number
Description Spare part number
Power connector cable M50400-001
Before removing the power connector cable, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 32).
2. Remove the bottom cover (see Bottom cover and rubber feet on page 32).
3. Remove the battery (see Battery on page 34).
4. Remove the display (see Display assembly on page 51).
Remove the power connector cable:
1. Disconnect the power connector cable from the system board (1).
2. Use a tool to release the power connector from the computer (2).
Reverse this procedure to install the power connector cable.
Keyboard with top cover
The top cover with keyboard remains after removing all other spare parts from the computer. In this section,
the rst table provides the main spare part number for the top cover/keyboards. The second table provides
the country codes.
Component replacement procedures 59
To Next Page
Loading...
Need help?
General
