The support file page includes the following information:
• System description
• Dual image status and descriptions
• Buffered log messages
• Logging configuration details
• SNTP configuration
• Time zone configuration
• Network details
• Web parameters
• Management access
• SNMP
• Port configuration details, summary, and statistics
• Trunk statistics
• Jumbo frames configuration details
• Storm control, Auto DoS, and Flow control configuration
• Web configuration
• MAC address forwarding table and summary statistics
• VLAN configuration and membership details
• Trunk status
• LLDP global mode details
• Interface mode details
• LLDP global and interface statistics, and local and remote device summaries
• Port mirroring configuration
• Loop protection status per interface
• Spanning tree bridge and interface status and configuration, and port settings
To save the Support File data to a file, click Save As located at the top and bottom of the page.
You can print the text from your text editor. Alternatively, your browser may support printing only
the frame that contains the data (that is, it excludes the navigation pane and Web Applet) directly
from the Web page. Right-click the data area to see if your browser provides this option.
Locator
The Locator LED is a special LED that enables locating the device physically. When enabling the
Locate setting via the Web interface, the Locate LED on the switch blinks for 30 minutes and then
turns off.
To display the Locator page, click Diagnostics > Locator in the navigation pane.
Figure 45 Locator Page
Locator 57
To Next Page
Loading...
Need help?
General
