Table 30 LLDP Local Device Fields (continued)
DescriptionField
Displays the system capabilities of the local system that are supported and enabled.
The default is Bridge.
Capabilities Enabled
LLDP Interface Description
The interface on which LLDP 802.1AB frames can be transmitted.LLDP Interface
The description of the selected port associated with the local system.Port Description
The source of the port identifier.Port ID
Displays the type of the source of the port ID.Port ID Subtype
Click the Refresh link above the page to update the page with the latest data from the switch.
LLDP Remote Device
Use the LLDP Remote Device page to view information about remote devices for which the switch
has received LLDP information.
To display the Remote Device page, click LLDP > Remote Device in the navigation pane.
Figure 38 LLDP Remote Device Page
Table 31 LLDP Local Device Fields
DescriptionField
The port on the local system that received the LLDP data from the remote system.Local Interface
The chassis component associated with the remote system.Chassis ID
The physical address of the port on the remote device that sent the LLDP data.Port ID
The port description configured on the remote device. If the port description is not
configured, the field is blank.
Port Description
The system description configured on the remote device. If the system description is not
configured, the field is blank.
System Name
The capabilities on the remote device.System Capabilities
The capabilities on the remote device that are enabled.Capabilities Enabled
IP address of the remote device.System IP
Click the Refresh link above the page to re-display the page with current settings from the switch.
Energy Efficient Ethernet
EEE (Energy Efficient Ethernet) is designed to save power by turning off network ports that are not
passing traffic. EEE includes a mechanism to awaken the port when it needs to send or receive
traffic. The transmitter sends LPI (low power idle) signals instead of the normal idle signals to indicate
that the EEE protocol is in effect. After a period of time called Ts (time to sleep), the transmitter
stops sending signals and the link is quiet. When the transmitter needs to send traffic, it begins
52 Link Layer Discovery Protocol (LLDP)
To Next Page
Loading...
Need help?
General
