Simple Programming 12–21
File name 32sii-Manual-E-0424
Printed Date : 2003/4/24 Size : 17.7 x 25.2 cm
which use only 1.5 bytes.
All other instructions use 1.5 bytes.
Equations use 1.5 bytes, plus 1.5 bytes for each function, plus 9.5 or 1.5
bytes for each number. Each "(" and each ")" uses 1.5 bytes except "("
for prefix functions.
If during program entry you encounter the message
&
"
, then
there is not enough room in program memory for the line you just tried to enter.
You can make more room available by clearing programs or other data. See
"Clearing One or More Programs" below, or "Managing calculator Memory"
in appendix B.
The Catalog of Programs (MEM)
The catalog of programs is a list of all program labels with the number of
bytes of memory used by each label and the lines associated with it. Press
z
X
{
} to display the catalog, and press
z
or
z
to move within the list. You can use this catalog to:
Review the labels in program memory and the memory cost of each
labeled program or routine.
Execute a labeled program. (Press
W
or
f
while the label is
displayed.)
Display a labeled program. (Press
z
d
while the label is
displayed.)
Delete specific programs. (Press
z
b
while the label is
displayed.)
See the checksum associated with a given program segment. (Press
{
.)
The catalog shows you how many bytes of memory each labeled program
segment uses. The programs are identified by program label:
)
where 61.5 is the number of bytes used by the program.
To Next Page
Loading...
Need help?
General
