Page 1-21
Selecting properties of the equation writer (EQW)
First, press the H button to activate the CALCULATOR MODES input form.
Within the CALCULATOR MODES input form, press the @@DISP@ soft menu key
(D) to display the DISPLAY MODES input form. Press the down arrow key,
˜, three times, to get to the EQW (Equation Writer) line. This line shows
two properties that can be modified. When these properties are selected
(checked) the following effects are activated:
_Small Changes font size to small while using the equation
editor
_Small Stack Disp Shows small font in the stack after using the equation
editor
Detailed instructions on the use of the equation editor (EQW) are presented
elsewhere in this manual.
For the example of the integral
∫
∞
−
0
dXe
X
, presented above, selecting the
_Small Stack Disp in the EQW line of the DISPLAY MODES input form
produces the following display:
References
Additional references on the subjects covered in this Chapter can be found in
Chapter 1 and Appendix C of the calculator’s User’s Guide.
To Next Page
Need help?
General
