HP A5830 Series User Manual

184
Figure 57 SSH client configuration interface 2)
Click Open to connect to the server. If the connection is normal, you are prompted to enter the
username. After entering the username (client002), you can enter the configuration interface of the
server.
SSH client configuration examples
When the switch acts as client for password authentication
Network requirements
As shown in Figure 58, Switch A (the SSH client) must pass password authentication to log in to Switch
B (the SSH server) through the SSH protocol. Configure the username client001 and the password
aabbcc for the SSH client on Switch B.
Figure 58 Switch acts as client for password authentication
Configuration procedure
1. Configure the SSH server.
# Generate the RSA key pairs.

HP A5830 Series Specifications

General

Brand	HP
Model	A5830 Series
Category	Switch
Language	English