HP Brio Assist CD-ROM
43
HP Brio Assist CD-ROM
Your PC comes with two HP Brio Assist CD-ROMs (Windows 98 version)
or three (Windows 2000 version):
• HP Brio Assist CD-ROM - System Recovery (1 or 2 CDs)
•
HP Brio Assist CD-ROM - Drivers & Utilities (1 CD)
HP Brio Assist CD-ROM - System Recovery
Use this CD-ROM to:
• perform a full system recovery
•
replace Windows 2000 with Windows NT 4.0 (feature available in some
countries only)
HP Brio Assist CD-ROM - Drivers & Utilities
Use this CD-ROM to:
• reinstall individual device drivers or utilities
•
run e-DiagTools hardware diagnostics.
Using the HP Brio Assist CD-ROMs
To use the HP Brio Assist CD-ROMs, you must either:
• boot the PC from the CD-ROM
• browse the CD-ROM while the PC is running.
Note
If the PC does not boot from the HP Brio Assist CD-ROM - System Recovery, you must change
the order of devices from which your PC tries to start up. To do so, restart your PC and press
F2
when prompted to enter the HP Setup program. Change the
Boot Device Priority
in the
Setup program
Boot
menu so that
ATAPI CD-ROM Drive
appears before
Hard Drive
(refer to
“Support and Information Services” on page 45
)
.
Performing a Full System Recovery or Alternative OS Installation
You can use the HP Brio Assist CD-ROM - System Recovery to recover
the PC’s factory supplied configuration by restoring the operating system
(OS), drivers and HP supplied applications. This will return the PC’s
software configuration to a state similar to when the PC was originally
shipped.
In some countries on Windows 2000 models, you can also replace the
preloaded Windows 2000 operating system with Windows NT 4.0.
To Next Page
Loading...
Need help?
General