10 Introduction
3 Set the autoloader configuration as follows:
Internal built-in autoloaders: set the switches on the rear of the autoloader
mechanism (see Figure 1).
External standalone autoloaders: the value of the option switch settings is
the number on the right when looking at the rear of the autoloader. To
change the number, click on the little buttons marked ‘−’ and ‘+’ above
and below the number with a ball-point pen or similar.
4 Switch the autoloader on again.
5 Ensure that the appropriate drivers and application software are installed
on the host computer.
To Next Page
Loading...
Need help?
General
