omnicheck
performs a DNS connections check within a Data Protector cell and lists Data Protector
patches installed on Data Protector clients
nl
(this command is available on systems with any Data Protector component installed)
omnicheck
SYNOPSIS
omnicheck -version | -help
omnicheck -dns [-host Client | -full] [-verbose]
omnicheck -patches -host Client
DESCRIPTION
The following tasks can be performed using the omnicheck command:
CHECKING DNS CONNECTIONS WITHIN A DATA PROTECTOR CELL
To check DNS connections within a Data Protector cell, use the -dns option with the
omnicheck command.
The omnicheck command does not verify DNS connections in general. It verifies
that DNS information matches over all communications relevant for Data Protector
among Data Protector cell members. The command reports only failed checks and
the total number of failed checks unless the -verbose option is specified.
It is possible to verify the following DNS connections in the Data Protector cell, using
the omnicheck command:
• To check that the Cell Manager and every Media Agent resolve DNS connections
to every Data Protector client in the same cell properly and vice versa, use the
-dns option.
• To check that a particular Data Protector client resolves DNS connections to every
Data Protector client in the same cell properly and vice versa, use the -host
option.
• To check all possible DNS connections in the cell, when every client resolves DNS
connections to all other clients in the same cell, use the -full option.
LISTING PATCHES INSTALLED ON DATA PROTECTOR CLIENTS
The omnicheck command can be used to list Data Protector patches installed on a
particular client. The omnicheck option used to list Data Protector patches installed
on a particular client is -patches.
Command line interface reference 293
To Next Page
Loading...
Need help?
General