NEW INSTALLATION OR RE-INSTALLATION OF THE SAME VERSION OF DATA
PROTECTOR
If Data Protector is not installed, then the command, depending on the selected
options, installs the Cell Manager, Installation Server, or every Data Protector software
component specified with the -install option. If none of these options are specified,
the command issues a prompt for every Data Protector software component supported
on the current system OS. Using this prompt, software components supported on the
current system OS can be confirmed or rejected for installation, or the execution of
the command can be canceled. There is no such prompt if the -install option is
specified.
UPGRADE FROM AN EARLIER VERSION OF DATA PROTECTOR
To upgrade your cell from the earlier versions of the product to Data Protector
A.06.11, proceed as follows:
• Upgrade the Cell Manager
• Upgrade the Installation Server
• Upgrade the clients
To upgrade the all Data Protector components on the system, run omnisetup.sh
without options. If the Installation Server is installed together with the Cell Manager,
or if it is installed without client components, it is upgraded automatically during the
Cell Manager upgrade.
If the Installation Server is installed with the client components, it is removed during
the Cell Manager upgrade. In this case, a new Installation Server must be installed
using the -IS option, after the upgrade finishes.
To add a client to the Cell Manager, specify the -install option. If the client not
residing on the Cell Manager is to be upgraded, the -install option does not
need to be specified. In this case, the setup selects the same components as were
installed on the system before the upgrade without issuing a prompt.
In all cases (new installation, re-installation or upgrade), the following applies when
using this command:
• When using the -install option, the software components not supported on
the current system OS and mistyped software components are skipped.
• On the Cell Manager only, when the installation or upgrade is started, you are
prompted to install the HP AutoPass utility (unless the -autopass option is
specified — if it is, the HP AutoPass utility is installed or upgraded without issuing
a prompt). If AutoPass is already installed on the system, it is automatically
upgraded, if the prompt is confirmed. When Data Protector is uninstalled from
378
To Next Page
Loading...
Need help?
General