certain Data Protector software component or not. If the client is to be upgraded,
this option does not need to be specified. In this case, the setup selects the same
components as were installed on the system before the upgrade without issuing
a prompt.
-CM
Installs/upgrades the Data Protector Cell Manager.
-IS
Installs/upgrades the Data Protector Installation Server with all push packages.
Note that the Installation Server can be upgraded only after the Cell Manager
in the Data Protector cell is upgraded.
-autopass
If this option is specified, the HP AutoPass utility is automatically installed. If
AutoPass is already installed on the system, it is automatically upgraded. This
option is to be used only on the Cell Manager.
Note that AutoPass is not available on Linux.
NOTES
This command requires that the
• Data Protector UNIX installation DVD is mounted on the system.
• DP_DEPOT and LOCAL_INSTALL folders are copied to the disk.
Before running the command make sure that no Data Protector backups or restores
are running on the system. The command must be executed using the default POSIX
ksh or pdksh (on Linux) shell.
On MC/ServiceGuard, the HP AutoPass utility must be installed an all nodes.
EXAMPLES
1. To upgrade a system, run:
omnisetup.sh
2. To install or re-install the General Media Agent, Disk Agent, SMIS-A and SAP
R/3 software components, run:
omnisetup.sh -install ma,da,smisa,sap
3. To install the Cell Manager and Installation Server together with the HP AutoPass
utility, insert and mount the UNIX installation DVD and run the following command
from the LOCAL_INSTALL directory:
380
To Next Page
Need help?
General