HP G2 Series User Manual

Heavy Duty Stabilizer kit
Kit overview
The Heavy Duty Stabilizer kit provides stability and support and prevents possible tipping when you install, remove, or access
equipment within the HPE Advanced G2 Series or HPE Enterprise G2 Series racks.
Use the heavy duty stabilizer kit if you have a stand-alone rack with a single rack-mountable component that exceeds 998 kg
(220 lb) or if you have three or fewer bayed racks with a single rack-mountable component that exceeds 998 kg (220 lb).
NOTE: This kit is only available for 600mm wide racks.
Kit contents (BW961A)
Item Quantity
Heavy duty front stabilizer mount 1
Heavy duty stabilizer feet 2
M8 x 16-mm bolt 8
M8 x 30-mm bolt 2
M8 flat washer 10
Required tools
The following tools are required for installation:
• Ratchet with sockets
• Adjustable wrench
Installing the heavy duty stabilizer
Procedure
1.
Install the front stabilizer mount.
a. Align the front stabilizer mount to the mounting holes on the rack front caster plate.
b. Insert and partially tighten four M8 x16-mm bolts with washers, securing the front stabilizer mount to the front caster
plate.
Heavy Duty Stabilizer kit
69

HP G2 Series Specifications

General

Brand	HP
Model	G2 Series
Category	Measuring Instruments
Language	English