xv
Figure 17 Installing a CF card
Installing an interface module
An HMIM or MIM interface module can be 1U or 0.5U. This section takes a 0.5U interface module for
example. When you install a 1U interface module to an MSR router, remove the filler panels of the target
slot and the neighboring slot above. When you install a 1U MIM interface module, you must use the 1U
HMIM adapter.
Installing an HMIM
You can install an HMIM when the router is powered on. However, before replacing an HMIM when the
router is powered on, you must execute the remove hmimslot slotnumber command.
The procedures for installing HMIMs and MIMs to the MSR4060 and MSR4080 routers are similar. This
section describes installation of HMIM 2E1 and MIM 2FE to the MSR4060.
To install an HMIM:
1. Remove the fastening screws with a Phillips screwdriver to remove the filler panel.
Keep the removed filler panel and screws in an anti-static bag for future use.
2. Push the HMIM slowly along the slide rails into the slot until it makes close contact with the
backplane of the router.
To Next Page
Loading...
Need help?
General
