HP MSR2000 Series Preparing For Installation

viii
Figure 48 Removing slide rails
Replacing a CF card
CAUTION:
Execute the umount cfb0: command before you remove the CF card if the router is powered on.
To replace a CF card:
1. Press down the spring clip of the CF card cover and open the cover.
2. Press the CF card eject button of the CF card reader so that the eject button projects from the panel.
3. Press the eject button again to eject the CF card part-way out of the CF card reader, and then pull
the CF card out of the CF card reader.
Keep the removed CF card for future use.
4. Install a new CF card. For the installation procedure, see "Installing the router."
If you do not install a new CF card, close the CF card cover.

HP MSR2000 Series Specifications

General

Brand	HP
Model	MSR2000 Series
Category	Network Router
Language	English