Removal of Palmrest Assy and Sub Battery Set (4.8V)
To remove the Palmrest Assy, first follow the instructions above to remove the HDD Drive, Center Bay Module (FDD Module, CD-ROM Assy, or
Enhanced Li-Ion Battery) and the Standard Li-Ion Battery. From the bottom of the unit, remove the four screws (Screw CPU M2.6 X 6L). Turn
unit right side up and place a thin flat instrument under the edge of the Palmrest Assy and pry up. The Palmrest Assy will snap up.
Lay the Palmrest Assy upside down on the keyboard. Slip the connector sleeves forward on the ribbon cable connectors on the underside of
the Palmrest and remove the ribbon cable. To remove the Sub Battery Set, remove the tape that holds the wires to the Upper Chassis case.
Next, remove the Sub Battery Set connector from the Palmrest Assy.
Reverse the procedure to reassemble.
25
To Next Page
Loading...
Need help?
General