HP Pro 2110 Small Form Factor User Manual

Rated Input Current (maximum)
1
6A @ 100 VAC 3A @ 200 VAC
1
This system utilizes a passive power factor corrected power supply. The power factor correction is present in the 230V
operating mode only. This allows the system to pass the CE mark requirements for use in the countries of the European Union.
This supply requires the use of an input voltage range select switch.
Small form factor models
Desktop Dimensions
Height
Width
Depth
4.43 in
12.25 in
15.33 in
11.25 cm
31.12 cm
38.94 cm
Approximate Weight
HP Pro 2110
HP Pro 3120
HP Pro 3130
14.75 lb
14.59 lb
14.60 lb
6.69 kg
6.62 kg
6.62 kg
Temperature Range
Operating
Nonoperating
50° to 95°F
-22° to 140°F
10° to 35°C
-30° to 60°C
Relative Humidity (noncondensing)
Operating
Nonoperating (38.7°C max wet bulb)
10-90%
5-95%
10-90%
5-95%
Maximum Altitude (unpressurized)
Operating
Nonoperating
10,000 ft
30,000 ft
3048 m
9144 m
NOTE: Operating temperature is derated 1.0° C per 300 m (1000 ft) to 3000 m (10,000 ft) above sea level; no
direct sustained sunlight. Maximum rate of change is 10° C/Hr. The upper limit may be limited by the type and
number of options installed.
Power Supply
Operating Voltage Range
Rated Voltage Range
Rated Line Frequency
115V
90-132 VAC
100-127 VAC
50-60 Hz
230V
180-264 VAC
200-240 VAC
50-60 Hz
Power Output
270 W 270 W
Rated Input Current (maximum)
1
6A @ 100 VAC 3A @ 200 VAC
1
This system utilizes a passive power factor corrected power supply. The power factor correction is present in the 230V
operating mode only. This allows the system to pass the CE mark requirements for use in the countries of the European Union.
This supply requires the use of an input voltage range select switch.
Small form factor models
195

HP Pro 2110 Small Form Factor Specifications

General

Brand	HP
Model	Pro 2110 Small Form Factor
Category	Desktop
Language	English