HP Pro 2110 Small Form Factor User Manual

Front I/O and USB Panel Housing Assembly
1.
Prepare the computer for disassembly (
Preparation for Disassembly on page 42).
2.
Remove the access panel (
Access Panel on page 43)
3.
Lay the computer on its side with the front facing toward you.
4.
Remove the front bezel (
Front Bezel on page 44).
5.
Unplug the two cables from the yellow and white system board connectors on the system board.
6.
Remove the screw that secures the housing to the chassis, and then pull the assembly away from
the chassis while guiding the cables through the hole in the chassis.
To install the housing assembly, reverse the removal procedures.
When installing the assembly, note that the assembly has hooks that fit into slots in the chassis, as
shown in the following images.
72 Chapter 5 Removal and Replacement Procedures Minitower (MT) Chassis

HP Pro 2110 Small Form Factor Specifications

General

Brand	HP
Model	Pro 2110 Small Form Factor
Category	Desktop
Language	English