HP Pro 2110 Small Form Factor User Manual

When installing the power supply, make sure the front I/O cables are in the clips under the power
supply.
Table 6-10 Country power supply settings
Country Voltage setting Country Voltage setting
Austria 230W Mexico 115W
Australia 230W The Netherlands 230W
Argentina 230W New Zealand 230W
Belgium 230W Portugal 230W
Brazil 230W Norway 230W
Canada 115W People's Republic of China 230W
Caribbean 230W Singapore 230W
Denmark 230W South Korea 230W
Finland 230W Spain 230W
France 230W Sweden 230W
Germany 230W Switzerland 230W
India 230W Taiwan 115W
Italy 230W Thailand 230W
Japan 115W The United Kingdom 230W
Latin America 115W The United States 115W
System Board
1.
Prepare the computer for disassembly (
Preparation for Disassembly on page 87).
2.
When replacing the system board, make sure the following components are removed from the
defective system board and installed on the replacement system board:
●
Memory modules (see
Installing Additional Memory on page 90)
●
Expansion cards (
Expansion Cards on page 97)
●
Heat sink (
Heat sink on page 122)
●
Processor (
Processor on page 123)
3.
Remove the access panel (
Access Panel on page 88).
4.
Remove the front bezel (
Front Bezel on page 89).
5.
Remove the system fan (
System Fan on page 103).
6.
Remove the drives (
Drives on page 109).
128 Chapter 6 Removal and Replacement Procedures Small Form Factor (SFF) Chassis

HP Pro 2110 Small Form Factor Specifications

General

Brand	HP
Model	Pro 2110 Small Form Factor
Category	Desktop
Language	English