HP Pro 2110 Small Form Factor User Manual

5.
If the computer has an Intel processor, go to steps 7 – 9.
6.
If the computer has an AMD processor, go to steps 10 – 11.
7. Rotate the locking lever to its full open position (1).
8. Raise and rotate the microprocessor retainer to its full open position (2).
9. Carefully lift the processor from the socket (3).
CAUTION: Do NOT handle the pins in the processor socket. These pins are very fragile and
handling them could cause irreparable damage. Once pins are damaged it may be necessary to
replace the system board.
CAUTION: The heat sink must be installed within 24 hours of installing the processor to prevent
damage to the processor’s solder connections.
NOTE: Steps 10 – 11 are for computers with AMD processors. See steps 7 – 9 for instructions
to remove Intel processors.
10. Rotate the locking lever to its full open position (1).
Processor
77

HP Pro 2110 Small Form Factor Specifications

General

Brand	HP
Model	Pro 2110 Small Form Factor
Category	Desktop
Language	English