To Next Page

To Previous Page

1-4

Switch Overview

Switch Hardware Features

■ If the Speed (Spd) indicator LED is lit, the port LEDs behave as follows

to indicate the connection speed for the port:

• Off = 10 Mbps

• Blinking = 100 Mbps (the flashing behavior is a repeated on/off cycle

once every 1.6 sec.)

• On = 1000 Mbps

Reset Button

This button is used to reset the switch while it is powered on. This action clears

any temporary error conditions that may have occurred and executes the

switch self test.

Clear Button

This button is used for these purposes:

■ Deleting Passwords - When pressed by itself for at least three seconds,

the button deletes any switch console access passwords that you may

have configured. Use this feature if you have misplaced the password and

need console access.

This button is provided for your convenience, but its presence means

that if you are concerned with the security of the switch configuration

and operation, you should make sure the switch is installed in a secure

location, such as a locked wiring closet.

■ Restoring Factory Default Configuration - When pressed with the

Reset button in a specific pattern, any configuration changes you may

have made through the switch console, the web browser interface, and

SNMP management are removed, and the factory default configuration is

restored to the switch. For the specific method to restore the factory

default configuration, see “Restoring to Factory Defaults” in chapter 4,

“Troubleshooting” of this manual.

Switch Features

The features of the ProCurve 1810G-8 Switch include:

■ 8 auto-sensing 10/100/1000Base-T RJ-45 ports.

■ plug-and-play networking—all ports are enabled—just connect the

network cables to active network devices and your switched network is

operational.

HP ProCurve 1810G-8 User Manual

Other manuals for HP ProCurve 1810G-8