File Transfers
Copying Software Images
Figure A-8. Switch-to-Switch, from Either Flash in Source to Either Flash in
Destination
Using PCM+ to Update Switch Software
ProCurve Manager Plus includes a software update utility for updating on
ProCurve switch products. For further information, refer to the Getting
Started Guide and the Administrator’s Guide, provided electronically with
the application.
Copying Software Images
Using the CLI commands described in this section, you can copy software
images from the switch to another device using tftp or xmodem.
Note For details on how switch memory operates, including primary and secondary
flash, refer to Chapter 6, “Switch Memory and Configuration”.
TFTP: Copying a Software Image to a Remote Host
Syntax: copy flash tftp < ip-addr > < filename >
This command copies the primary flash image to a TFTP
server.
For example, to copy the primary flash to a TFTP server having an IP address
of 10.28.227.105:
ProCurve# copy flash tftp 10.28.227.105 k0800.swi
where k0800.swi is the filename given to the flash image being copied.
A-22
To Next Page
Loading...
Need help?
General