EasyManuals Logo
Home>HP>Switch>ProCurve 2810 Series

HP ProCurve 2810 Series User Manual

HP ProCurve 2810 Series
420 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #237 background imageLoading...
Page #237 background image
Port Trunking
Port Status and Configuration
Half-Duplex and/or Different Port Speeds Not Allowed in LACP
Trunks. The ports on both sides of an LACP trunk must be configured for
the same speed and for full-duplex (FDx). The 802.3ad LACP standard speci-
fies a full-duplex (FDx) requirement for LACP trunking.
A port configured as LACP passive and not assigned to a port trunk can be
configured to half-duplex (HDx). However, in any of the following cases, a
port cannot be reconfigured to an HDx setting:
If a port is set to LACP Active, you cannot configure it to HDx.
If a port is already a member of a static or dynamic LACP trunk, you cannot
configure it to HDx.
If a port is already set to HDx, the switch does not allow you to configure
it for a static or dynamic LACP trunk.
Dynamic/Static LACP Interoperation: A port configured for dynamic
LACP can properly interoperate with a port configured for static (TrkX) LACP,
but any ports configured as standby LACP links will be ignored.
Trunk Group Operation Using the “Trunk” Option
This method creates a trunk group that operates independently of specific
trunking protocols and does not use a protocol exchange with the device on
the other end of the trunk. With this choice, the switch simply uses the SA/DA
method of distributing outbound traffic across the trunked ports without
regard for how that traffic is handled by the device at the other end of the
trunked links. Similarly, the switch handles incoming traffic from the trunked
links as if it were from a trunked source.
Use the Trunk option when you are trying to establish a trunk group between
the switch and another device, but the other device’s trunking operation fails
to interoperate properly with LACP trunking configured on the switch itself.
How the Switch Lists Trunk Data
Static Trunk Group: Appears in the menu interface and the output from the
CLI show trunk and show interfaces commands.
Dynamic LACP Trunk Group: Appears in the output from the CLI show lacp
command.
11-23

Table of Contents

Other manuals for HP ProCurve 2810 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP ProCurve 2810 Series and is the answer not in the manual?

HP ProCurve 2810 Series Specifications

General IconGeneral
BrandHP
ModelProCurve 2810 Series
CategorySwitch
LanguageEnglish

Related product manuals