File Transfers
Downloading Switch Software
7. After the primary flash memory has been updated with the new operating
system, you must reboot the switch to implement the newly downloaded
software. From the Main Menu, press
[6] (for Reboot Switch). You will then
see this prompt:
Continue reboot of system? : No
Press the space bar once to change No to Yes, then press
[Enter] to begin
the reboot.
8. To confirm that the operating system downloaded correctly:
a. From the Main Menu, select
Status and Counters
General System Information
b. Check the Firmware revision line.
CLI: Switch-To-Switch Downloads
You can download a switch software file between two switches that use the
same code base and which are connected on your LAN. To do so, use a copy
tftp command from the destination switch.The options for this CLI feature
include:
â– Copy from primary flash in the source to either primary or secondary in
the destination.
â– Copy from either primary or secondary flash in the source to either
primary or secondary flash in the destination.
Downloading from Primary Only. This command (executed in the destina-
tion switch) downloads the switch software from the source switch’s primary
flash to either the primary or secondary flash in the destination switch.
Syntax: copy tftp flash < ip-addr > flash [primary | secondary]
If you do not specify either a primary or secondary flash location for the
destination, the download automatically goes to primary flash.
For example, to download switch software from primary flash in a switch with
an IP address of 10.28.227.103 to the primary flash in the destination switch,
you would execute the following command in the destination switch’s CLI:
A-15
To Next Page
Loading...
Need help?
General