To Next Page

To Previous Page

File Transfers

Transferring Switch Configurations

TFTP: Copying a Configuration File to a Remote Host.

Syntax: copy < startup-config | running-config > tftp < ip-addr > < remote-file >

This command copies the switch’s startup configuration (startup-config file)

to a remote TFTP host.

For example, to upload the current startup configuration to a file named

sw2810 in the configs directory on drive “d” in a remote host having an IP

address of 10.28.227.105:

ProCurve# copy startup-config tftp 10.28.227.105

d:\configs\sw2810

Xmodem: Copying a Configuration File from the Switch to a Serially

Connected PC or Unix Workstation. To use this method, the switch must

be connected via the serial port (this is an RJ45 port on the front panel of the

2810 switch) to a PC or Unix workstation to which you want to copy the

configuration file. You will need to:

■ Determine a filename to use.

■ Know the directory path you will use to store the the configuration file.

Syntax: copy < startup-config | running-config > xmodem < pc | unix >

For example, to copy a configuration file to a PC serially connected to the

switch:

1. Determine the file name and directory location on the PC.

2. Execute the following command:

ProCurve# copy startup-config xmodem pc

3. After you see the following prompt, press

[Enter].

Press ’Enter’ and start XMODEM on your host...

4. Execute the terminal emulator commands to begin the file transfer.

A-19

HP ProCurve 2810 Series User Manual

Other manuals for HP ProCurve 2810 Series