Troubleshooting
Using Logging To Identify Problem Sources
Shows that Syslog (Destination) logging is
enabled and transmitting log messages to IP
address 18.120.38.155. Also shows that the
logging facility is set to user (the default), and
that session logging is enabled.)
Disables Syslog logging (but retains the
Syslog IP address in the switch
configuration). Does not affect Session
logging.
Shows Syslog (Destination) logging now
disabled. Session logging continues to
operate.
Figure C-11. Example of Disabling Syslog Operation
Viewing Debug (Syslog and Session) Status. Use these commands to
determine the current debug configuration and status:
Syntax: show < config | running >
Lists the current startup-config or running-config file, with
any currently configured IP addresses for SyslogD servers.
ProCurve(config)# show Config
Startup Configuration:
; J9022A configuration Editor; Created on release #N.10.XX
hostname "ProCurve switch"
time daylight-time-rule None
cdp run
logging 10/120/38/155
logging 10.12043.125
snmp-server community "public" Unrestricted
ip default-gateway 10.38.224.1
The configured Syslog server IP
addresses appear in the switch’s
configuration file, even if Syslog
logging is disabled.
Figure C-12. Example of Show Config Output with SyslogD Servers Configured
C-32
To Next Page
Loading...
Need help?
General