13
The 8200zl Management Modules are hot-swappable—the switch does not have to be powered-off to remove
either management module. The dual management module (MM) design allows either module to manage the
system in an active/standby model. By default, MM1 will assume the “active” role; but in general, whichever
MM was the last one to be “active”, the other MM will assume the “standby” role. All operations are performed
through the “active” MM (either MM1 or MM2). If the active MM were to fail, the standby MM takes control of
the switch and continues operation. However, if only one management module is running and then is removed,
all ports lose communication and the system will be powered down.
Switch 8206zl Chassis layout
The Switch 8206zl is a rack-mountable, 6U-height chassis. The interface modules are inserted in the front slots,
labeled A through F. Management and fabric modules are labeled MM1/MM2 and FM1/FM2, respectively.
Figure 3. J8715A HP ProCurve Switch 8212zl Base System slot labeling
(MM = Management Module; FM = Fabric Module; all others = Interface Module)
Switch 8200zl series-specific modules and components
The Switch 8200zl Series shares interface modules and power supplies with the Switch 5400zl series. This next
section will cover details of modules and components specific to the 8200zl series.
J9092A HP ProCurve 8200zl Management Module
J9093A 8200zl
Fabric Modules
Power, Fault, Locator LEDs
J9092A 8200zl
Management Module
J9095A System
Support Module
Slot A
Slot C
Slot E
Slot B
Slot D
Slot F
MM1
MM2
FM2
FM1
2nd
Management
Module slot
To Next Page
Loading...
Need help?
General