HP t5400 - Thin Client User Manual

DOS Command-line Tool Boot Commands
The following table lists the EWF boot commands that are supported.
Boot Command Description
All Displays information about all protected volumes and performs a command, such as disable, enable,
and commit, on each volume if specified.
Commit Commits all current level data in the overlay to the protected volume, and resets the current overlay
level to 1 upon shutdown.
Disable Allows user to write to the image after the next reboot.
Enable Prevents the user from writing to the image after the next reboot.
Commitanddisable Combination of the Commit and Disable commands. This command will commit data in the overlay
upon shutdown. Additionally, EWF will be disabled after the system reboots.
NOTE: When using the Commit boot command, all the temporary contents will be permanently
written to the flash memory. In addition, all content accessed (and changes made) after running
Commit, but before rebooting the system, will be written to the flash memory as well. This includes
changes made during any number of login/logout sessions before the next reboot.
Using Boot Commands
To use the EWF manager boot commands, type the following syntax in a command prompt:
EWFMGR <drive-letter> —[boot command].
NOTE: Because the EWF manager commands are executed on the next boot, you must reboot the
system for the command to take effect.
36 Chapter 5 Control Panel Extended Selections ENWW

HP t5400 - Thin Client Specifications

General

Brand	HP
Model	t5400 - Thin Client
Category	Server
Language	English

Summary

About This Document

WARNING!

Indicates failure to follow directions could result in bodily harm or loss of life.

CAUTION:

Indicates failure to follow directions could result in damage to equipment or loss of information.

Introduction to WES 2009 Thin Clients

Server Environment Requirements

Services required for HP thin clients accessed through a network.

Session Services Overview

Network services required for thin client connectivity.

Thin Client Management Services

HP's suite of management solutions for thin clients.

Altiris Deployment Server

Tool for quick deployment and ongoing management of thin clients.

Configuration

Logging On

Procedures for logging onto the thin client automatically or manually.

Automatic Logon

Enabling or disabling auto logon and configuring user name, password, domain.

Applications

HP ThinState

Tool to capture and deploy HP thin client images.

HP ThinState Capture

Wizard-based tool to capture an HP thin client WES 2009 image.

HP ThinState Deploy

Process to deploy captured images to other HP thin clients.

Control Panel Extended Selections

Write Filters

Protecting the operating system from undesired flash memory writes.

Choosing the Write Filter

Selecting between Enhanced Write Filter (EWF) and File-Based Write Filter (FBWF).

Enhanced Write Filter Manager

Manages Enhanced Write Filter settings via GUI or command line.

File-Based Write Filter Manager

Manages File-Based Write Filter settings and file/folder exclusions.

File-Based Write Filter GUI

GUI for configuring EWF and FBWF settings and exclusions.

Administration and Image Upgrades

HP Device Manager

Server-based application for centralized administration of HP thin clients.

HP Client Automation

Enterprise-wide client management solution for physical and virtual clients.

HP ThinState Capture and Deploy

Tool to capture and deploy HP thin client images.

Altiris Deployment Solution Software

Remote administration tool set accessing clients via Altiris remote Agent.

HP Compaq Thin Client Imaging Tool

Utility to restore the original factory image to the thin client.