FusionModule5000 Smart Modular Data Center
Product Description (ECC800)
One 12 V DC power output that controls magnetic locks, phoenix terminal
One DI input port for connecting to the door status switch
RS485 serial
port
expansion
Two RS485 ports (one route) with the default communications rate of
9600 bit/s, physical port cascading supported (reserved function)
Two Wiegand interfaces, 12 V DC card reader operating power output;
two routes of card readers can operate at the same time.
⚫
Press the button for less than 1 second to start blinking.
⚫
Hold down the button for 1–5 seconds to search for a network and start
networking.
⚫
Hold down the button for more than 6 seconds to clear network
parameters.
Indicators
Table 3-50 describes the access actuator indicators.
Table 3-50 Access actuator indicator description
Power input
status indicator
The power input is normal.
Communication
status indicator
The power is abnormal or the board
program is loading.
Blinking at
long intervals
The access actuator successfully
registers with the ECC800 and the
software runs properly (the
indicator blinks at 0.5 Hz, on for 1s
and then off for 1s).
Blinking at
short intervals
The communication is disconnected
or the access actuator fails to
register with the ECC800 (the
indicator blinks at 4 Hz, on for
0.125s and then off for 0.125s).
To Next Page
Loading...
Need help?
General
