Operation Manual - Getting Started
Quidway S5000 Series Ethernet Switches Chapter 4 User Interface Configuration
4-2
z Number of VTY: The first VTY interface is designated as VTY 0, the second one is
designated as VTY 1, and so on.
4.2 User Interface Configuration
User interface configuration includes:
z Enter user interface view
z Configure the user interface-supported protocol
z Configure the Attributes of AUX (Console) Port
z Configure the Terminal Attributes
z Manage users
z Configure redirection
4.2.1 Enter User Interface View
The following command is used for entering a user interface view. You can enter a
single user interface view or multi user interface view to configure one or more user
interfaces respectively.
Perform the following configuration in system view.
Table 4-1 Enter user interface view
Operation Command
Enter a single user interface view or multi user interface views
user-interface [ type ] first-number
[ last-number ]
4.2.2 Configure the User Interface-supported Protocol
The following command is used for setting the supported protocol by the current user
interface. You can log in switch only through the supported protocol. The configuration
become effective when you log in again.
Perform the following configurations in user interface (VTY user interface only) view.
Table 4-2 Configure the user interface-supported protocol
Operation Command
Configure the user interface-supported protocol protocol inbound { all | ssh | telnet }
By default, the user interface only supports Telnet protocol.
To Next Page
Loading...
Need help?
General