Operation Manual - Getting Started
Quidway S5000 Series Ethernet Switches Chapter 5 System IP Configuration
5-7
Table 5-8 Configure the default preference of static routes
Operation Command
Configure the default preference value of static routes
ip route-static default-preference
default-preference-value
Remove the default preference value of static routes configure undo ip route-static default-preference
By default, its value is 60.
5.3 Display and Debug System IP
After the above configuration, execute display command in any view to display the
running of the system IP configuration, and to verify the effect of the configuration.
Table 5-9 Display and debug system IP
Operation Command
View all the hosts and their IP addresses on the network display ip host
View related IP information of the management VLAN
interface
display ip interface vlan-interface vlan-id
View related information of the management VLAN interface display interface vlan-interface [ vlan_id ]
View routing table summary display ip routing-table
View routing table details display ip routing-table verbose
View the detailed information of a specific route
display ip routing-table ip-address [ mask ]
[ longer-match ] [ verbose ]
view the route information in the specified address range
display ip routing-table ip_address1 mask1
ip_address2 mask2 [ verbose ]
To Previous Page
Loading...
Need help?
General