Operation Manual - Getting Started
Quidway S5000 Series Ethernet Switches Chapter 4 User Interface Configuration
4-3
Caution:
1) If Telnet protocol is specified, to ensure a successful login via the Telnet, you must configure the
password by default.
2) If SSH protocol is specified, to ensure a successful login, you must configure the local or remote
authentication of username and password using the authentication-mode scheme command. The
protocol inbound ssh configuration fails if you configure authentication-mode password and
authentication-mode none. When you configure SSH protocol successfully for the user interface, then
you cannot configure authentication-mode password and authentication-mode none any more.
4.2.3 Configure the Attributes of AUX (Console) Port
The following commands can be used for configuring the attributes of the AUX
(Console) port, including speed, flow control, parity, stop bit and data bit.
Perform the following configurations in user interface (AUX user interface only) view.
I. Configure the transmission speed on AUX (Console) port
Table 4-3 Configure the transmission speed on AUX (Console) port
Operation Command
Configure the transmission speed on AUX (Console) port
speed speed-value
Restore the default transmission speed on AUX (Console) port undo speed
By default, the transmission speed on AUX (Console) port is 9600bps.
II. Configure the flow control on AUX (Console) port
Table 4-4 Configure the flow control on AUX (Console) port
Operation Command
Configure the flow control on AUX (Console) port flow-control { hardware | none | software }
Restore the default flow control mode on AUX (Console) port undo flow-control
By default, the flow control on the AUX (Console) port is none, that is, no flow control
will be performed.
To Next Page
Loading...
Need help?
General